Case Study: 5 × 10 m P25 Flying LED Screen in Ramat Gan, Israel
Published: 12 May 2026 | Location: Ramat Gan, Israel | Category: Drone LED display, aerial advertising
On 11 May 2026, a 5 × 10 m flying LED mesh screen was flown above Ramat Gan, Israel — a 50 m² aerial display carried by a heavy-lift drone. This page documents the format, the hardware behind it and the engineering constraints that decide whether a screen of this size can be flown safely and read clearly from the ground.
Project footage: the 5 × 10 m P25 mesh screen in operation above Ramat Gan.
1. What Was Flown
The display is a flexible LED mesh, not a rigid cabinet wall. The mesh format matters in the air for three reasons: it weighs little per square metre, air passes through it, and it can be rolled for transport. For a 50 m² surface, all three determine whether the project is viable.
The screen was configured as a 5 × 10 m format at 25 mm pitch, giving 200 × 400 pixels — 80,000 RGB pixels in total. Content was therefore prepared for that native resolution rather than at 1080p and scaled down.
2. Why P25 for a 50 m² Airborne Screen
Pitch choice in the air is a trade-off between payload and legibility, not a case of "finer is better". At 25 mm, a 50 m² screen delivers enough resolution for logos, product shots and short text at typical outdoor viewing distances, while keeping the mesh light enough for a single heavy-lift platform.
| Parameter | Value | Why it matters in flight |
|---|---|---|
| Pixel pitch / density | 25 mm / 1,600 dots per m² | Sets legibility against payload |
| Brightness | 2,800 nits | Suited to evening and controlled-light shows; daylight legibility needs a site test |
| Grayscale | 16-bit featured, 8-bit option | Smoother gradients in video content |
| Refresh rate | 3,840 Hz | Reduces banding on camera |
| Transparency | 70% | Lower wind load and less visual blocking |
| Mesh weight | 0.7 kg per m² | Payload budgeting (excludes batteries, cables, rigging) |
| Power | 200 W/m² max, 120 W/m² average | Drives battery count and flight duration |
| Ingress protection | IP65 | Enclosure protection only — not a flight-weather rating |
Mesh weight does not include batteries, cables, suspension hardware or the drone interface. Total system weight must be calculated for the specific configuration.
3. What a 50 m² Screen Demands Operationally
- Payload calculation: screen mass, battery packs, rigging and the drone interface are added together, then compared with the aircraft's approved payload margin — not its maximum figure.
- Wind area: a 70% transparent mesh reduces load compared with a solid panel, but a 50 m² surface still presents significant area at altitude. Operating limits come from the aircraft and rigging design.
- Flight duration: runtime scales with battery configuration and brightness. Published figures for this format are typically around 50–60 minutes; actual duration must be confirmed for the delivered pack.
- Permissions and site: aerial advertising in an urban area requires aviation approval, a defined operating area, separation from spectators and coordination with local authorities.
- Crew: pilot, screen technician and ground safety lead at minimum, plus a site-specific emergency procedure.
4. Content Rules for an Airborne Screen
A 200 × 400 pixel canvas behaves very differently from a ground-based billboard. Practical rules from this project:
- Design at native resolution — 200 × 400 px for a 5 × 10 m P25 screen; text set for a 1080p canvas will be unreadable.
- Short text only — three to five words per frame at typical viewing distance; longer lines lose legibility as the screen moves.
- High contrast, large shapes — silhouettes and bold blocks survive motion and camera compression better than fine detail.
- Plan for movement — the screen drifts and rotates slightly; keep key information centred and avoid edge-critical compositions.
- Test on camera — verify the 3,840 Hz refresh against the cameras actually covering the event.
5. Where This Format Works
For larger canvases, several screens can run synchronized playback: either the same content on every screen, or one composition split across screens. See the multi-screen synchronization guide for how the two modes differ.
6. Delivery Scope as a Manufacturer
We supply the screen system and project-specific hardware: mesh screen, power packs, control components, rigging hardware and technical documentation. Drone supply and local flight permissions depend on the project and are agreed separately with the operator and the client.
Available options include 8-bit or 16-bit grayscale, alternative pixel pitches (P20, P50) and custom screen dimensions. Compliance documentation for your destination market should be requested for the specific order rather than assumed from a general certification list.
7. Frequently Asked Questions
How large is a 5 × 10 m flying LED screen?
50 m² of display area. At 25 mm pitch that is 200 × 400 pixels, or 80,000 RGB pixels.
Can it be seen in daylight?
The P25LMP is rated at 2,800 nits, which suits evening and controlled-light conditions. Daylight legibility depends on sun angle, background and viewing distance — verify with a site test rather than assuming a specification figure guarantees readability.
How long can it stay airborne?
Flight duration depends on the battery configuration, brightness setting and the aircraft's payload margin. Published figures for this format are around 50–60 minutes; the delivered configuration should be confirmed in the quotation.
Does IP65 mean it can fly in rain?
No. IP65 describes enclosure protection. Flight in precipitation depends on the aircraft, the rigging and the operator's risk assessment.
Can several screens show one image?
Yes, with project-configured NovaStar control and RF synchronization. Screens can either mirror the same content or each carry a section of one composition; physical spacing and viewing angle must be planned.
Do you supply the drone and the pilot?
We supply the screen system. Drone supply and local operation are arranged per project with the operator, since aviation permissions and insurance are location-specific.
Request a Project Quote
Send your screen size, drone model and payload, event location, required flight duration and content format. We will confirm the mesh configuration, battery plan and rigging requirements.